Model: ML-SJG-S
Motor Power: 3 Kw
Weight: 220 Kgs
Dimension: 1600X780X2000 mm
Electricity:380V,50Hz,3 Ph
Usage Description:Collecting Rubber Crumbs which buffed off old tread by Buffing
Machine
Multifunctional Repair Stand
Model: ML-XTJ-M
Power: 0.18 Kw
With advances in state-of-the-art repair materials and repair
methods, many of these tyres can be routinely repaired and in most
cases can be retreaded when the original tread is worn off. The
repair station is where any surface injury is treated using
effective material and tools for grinding and patching.
Rubber Extruder Machine
Even in small injuries it is critical that the injury is cleaned
and filled. If this is not done, severe rust, separation and steel
cable looseness could take tyre out of service. The injury should
be inspected, and then cleaned out with a carbide cutter. After
cementing the injury, a vulcanizing rubber stem should be applied
to “fill” the injury. This would create a permanent repair that
maximizes tyre life.
Cement Mixing Tank
Model:ML-JBJ-FB
Weight:90 Kgs
Motor Power: 1.5 Kw
Dimension: 800x800x1500 mm
Usage Description: Engineered with explosion-proof motor,Cement
Mixing Tank stir industrial solvent and rubber materials evenly to
guarantee the procedure of cement spraying.
Tread Building Machine
Model: ML-TBM-F
Dimension: 1800x2100x2100 mm
Wheel Chuck:15'',16''-20'',22.5''
In the Pre-cure Tire Retreading System, the Tread Rubber has
already been vulcanized with the new tread pattern design. The
buffed tire needs a thin layer of cushion gum to be wrapped around
its crown area. The Pre-cured Tread Rubber(PTR) is then applied
with the building machine. This is called the MELION Building
Process.
Model:Ml-BFT-H
Dimension:1600x1500x2200 mm
Operate the air cylinder and drive the Spreading Arms outwards to
spread the Envelope. Then open the Gripper and grip the bead, and
then lift the tire up with the cylinder-driven cable wire and
guiding pulley. Rotate the lifting arm and lower the tire into the
center of the Spreading Arms, and put it into the envelop.
Manipulate the Air Cylinder to retrieve the Spreading Arms and
release the Spreading Pads off the Envelop. Then lift the tire out
of the Spreader.
Monorail System
Model: ML-GDJ-A
Dimension: 4000x1600x2100 mm
Description:
The monorail & hooks system increase productivity by reducing
chances of casing contamination and allows for faster loading and
unloading of tires.This increases your work place safety and
productivity.
Curing Chamber
Model:ML-LHG-12
Dimension: 5500x2100x2350 mm
Heating Power:60 Kw
Usage:The Tires are then placed in Curing Chamber and the pre-cured
tread becomes adhered to the tyre through a vulcanizing process.
